Engine Factory

Visit our community sponsor

Tab Content
  • feadam's Avatar
    07-16-2017, 12:10 PM
    feadam started a thread Body removal in Roadster
    For you guys that have done complete builds, how many times during build prices did you have to put body on and remove for measurement for...
    11 replies | 466 view(s)
  • feadam's Avatar
    07-11-2017, 06:56 PM
    So was going to use the stock type springs and shocks on rear but now leaning toward coil overs from FF5. Anybody using stock suspension or used it...
    2 replies | 230 view(s)
  • feadam's Avatar
    07-08-2017, 08:41 PM
    feadam replied to a thread toploader trans in Roadster
    Thanks Gordon, I have the transmission from a 66 fairline from a 390 car. Short tail 28 spline from what I found researching. I will hit you up as...
    6 replies | 335 view(s)
  • feadam's Avatar
    07-08-2017, 10:21 AM
    feadam replied to a thread toploader trans in Roadster
    for drive shaft can I use the drive shaft that ff5 sells? trans is about same length, spline is 28, so i'm assuming it will work.
    6 replies | 335 view(s)
  • feadam's Avatar
    07-07-2017, 08:42 PM
    feadam started a thread toploader trans in Roadster
    Has anyone installed a toploader behind an FE, if so did it need any special work to get it to work?
    6 replies | 335 view(s)
  • feadam's Avatar
    07-06-2017, 09:19 PM
    Has anyone used a to-loader 4 speed behind an FE 427 in the mk 4? If so what problems did you encounter?
    0 replies | 560 view(s)
  • feadam's Avatar
    06-25-2017, 04:01 PM
    Finally back in states in Owings Maryland. Car is in my garage but waiting on storage from Colorado for engine and trans. Has anyone used a 4 speed...
    15 replies | 2655 view(s)
  • feadam's Avatar
    06-25-2017, 02:41 PM
    feadam replied to a thread upper control arms in Roadster
    The video shows using washer behind forward bolt, manual doesn't say for top mount to use washer, do you use the washer for top mount under nut?
    5 replies | 466 view(s)
  • feadam's Avatar
    06-25-2017, 10:47 AM
    feadam started a thread upper control arms in Roadster
    installed upper control arms and want to make sure i mounted them right. The manual says use the top mounts, the video ff5 makes shows them on side...
    5 replies | 466 view(s)
No More Results
About feadam

Basic Information

About feadam
Biography:
Purchased Mk4 cobra 8870. Have 427 type fe motor BBM block heads 2-4 bbl motor top loader. Name is Adam Matteson have had two cobras. Retired from Air Force, Now following wife who is in a.f. she is currently teaching at A.F. academy. Possibly moving to Italy next year. Have a new 427 and top loader for new cobra, just been collecting parts. Sold my Everett- Morrison
Location:
Owings, Maryland
Occupation:
retired A.F.

Statistics


Total Posts
Total Posts
44
Posts Per Day
0.04
Albums
Total Albums
4
Total Photos
20
General Information
Last Activity
Today 08:50 AM
Join Date
07-24-2014
Referrals
0

Brown County Customs

Visit our community sponsor