Wayne Presley/VeryCoolParts Build Thread H6 power

[Hindsight]

Nice job Wayne... I bet the sound is totally worth it. Seems the torque peak is kinda high in the RPM band though.... could it come down with some more tuning and adjustment?

[Canadian818]

Good work as always Wayne! I'd be interested in the clutch depending on the details of course. I need a pull-type clutch for the 5mt in the 340ft/lbs range.

[Wayne Presley]

Nice job Wayne... I bet the sound is totally worth it. Seems the torque peak is kinda high in the RPM band though.... could it come down with some more tuning and adjustment?

The peak torque follows the boost curve, If I went with a smaller AR on the turbine housing it would lower the peak torque RPM a few hundred RPM.

Good work as always Wayne! I'd be interested in the clutch depending on the details of course. I need a pull-type clutch for the 5mt in the 340ft/lbs range.

It's a pull type stage 3 rated at 485 TQ, new they are $620, I'll sell it for $390

[Canadian818]

It's a pull type stage 3 rated at 485 TQ, new they are $620, I'll sell it for $390

That's probably heavier duty then I need, but the price is right. I'll take it, pm me how to proceed.

[Wayne Presley]

I'll get out on Friday

[Canadian818]

I'll get out on Friday

Thanks, whenever it's convenient is fine, won't be installed for months.

[fastfox]

There's TONS of air left in that turbo too!

[Wayne Presley]

There's TONS of air left in that turbo too!

Yes!

[alpine227]

Have you found any need for additional case ventilation with pcv or extra breathers on the valve covers?

[Wayne Presley]

No I haven't needed any extra breathers

[vicious_fishes]

I'm looking to turbo my H6, very interested to know exactly what turbo it is/for a spool plot/picture of the exhaust manifold and charge pipes?