dash cover block plates

[John Dol]

What have you guys done to close this are in. Seems it only blocks part of the hole.
Pic's would be great!

Thanks,

John

[Fluge]

Hi John

Surprise surprise...I made new ones. Actually, in all fairness, because I used a different dash I had to make new ones. I used the same idea but instead of the lower tab you show going out to the frame I made tabs so that they are under the the end piece. I also used a piece of bulb trim along the edge that goes up the roll bar.

I'll try to dig up a picture for you.

Marc

[Fluge]

Here you go. An early version but you get the point.



Marc

[CJBergquist]

x2 what Marc said...surprise, surprise...I made replacements. In final assembly the tab went on the outside of the body.

[John Dol]

Great thanks guys!

John

[TimC]

Unlike everyone else I made a new one.

[loeffler1]

John

Look through your photos you took of my coupe. There must be one showing the side and pillar covers I made and had powder coated in wrinkle black. If you can't find any let me know and I'll take a picture of the covers and e-mail it to you. They are not installed at the moment until I get the windshield installed and then I'll put them on. They were made to cover the area from mid dash area right up to the top roll bar area.

[John Dol]

OK Bill, I'll have a look.

John