Anyone know the pin out for Denso 36010FE020 Throttle Pedal Assembly?
I'm assuming the DBW pedal outputs 0-5VDC when powered by 12VDC bus, but I don't have the associated pin out. Pedal should be from an 06 WRX. I read a post on NASIOC stating the following pin out:
6 - Sensor
5 - GND
4 - PWR
I tried this, but the senor lead (referenced to GND) didn't move when the pedal was depressed.
I'm assuming the DBW pedal outputs 0-5VDC when powered by 12VDC bus, but I don't have the associated pin out. Pedal should be from an 06 WRX. I read a post on NASIOC stating the following pin out:
6 - Sensor
5 - GND
4 - PWR
I tried this, but the senor lead (referenced to GND) didn't move when the pedal was depressed.
Thanks Bob_n_Cincy! You wouldn't happen to know the signal names of each connection? From looking at the schematic pin 2 is GND. I am interested in knowing if the pedal has a 0-5VDC out for an EV conversion.
Thanks Bob_n_Cincy! You wouldn't happen to know the signal names of each connection? From looking at the schematic pin 2 is GND. I am interested in knowing if the pedal has a 0-5VDC out for an EV conversion.
On the 06 wrx pedal:
Pin 1 red/blue is +5v power from the ecu internal power supply ecu B22.
pin 2 red/green is sensor ground b30
pin 3 blue APS signal 2 ecu b31
pin 4 light green APS +5v ecu b21
pin 5 yellow APS Ground ecu b29
pin 6 red APS signal 1 b23
Pin 1,2 & 3 is one potentiometer and pins 4,5 & 6 is a second potentiometer.