Boig Motorsports

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: Rollbar Installation : shouldn't be this hard

  1. 03-27-2015, 10:50 PM #1
    jakester888
    jakester888 is offline
    Senior Member jakester888's Avatar
    Join Date
    Jun 2011
    Location
    Portland, OR
    Posts
    444
    Post Thanks / Like

    Rollbar Installation : shouldn't be this hard

    I need a recommendation on how to get the rollbar 3rd leg to line up with the hoop. Does this naturally occur at the fully seated position or 1" higher with a good torque on the 3rd leg to fit?

    In the photos shown below, this is in the fully seated position... seems like it doesn't align well. Am I doing something wrong or is this a possible jig alignment issue from FFR? I would believe the former rather than the latter.

    Img_3194.jpg Img_3193.jpg Img_3192.jpg
    Reply With Quote Reply With Quote
  2. 03-27-2015, 11:47 PM #2
    jakester888
    jakester888 is offline
    Senior Member jakester888's Avatar
    Join Date
    Jun 2011
    Location
    Portland, OR
    Posts
    444
    Post Thanks / Like
    Solution : Dremel & WD40. Also, it does not align well at fully seated position and seems to favor 1/2" above full seat.

    Img_3196.jpg Img_3195.jpg
    Last edited by jakester888; 03-27-2015 at 11:49 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

FFMetal

Visit our community sponsor