I'm really struggling with my headlight install. With a few hours work we managed to get the drivers side headlight installed and fitting pretty well. As with most people I had to do pretty significant trimming on the eyelid.

However, we can not get the passenger side to fit. I've trimmed as much eyelid as I dare and I just can't get the top of the light to roll back and up far enough to get the bottom of the light anywhere close. After fighting with it for about 5 hours I started taking measurements and discovered that the height of the headlight opening on the passenger side is 1/2 inch less than the divers side.

HeadlightProblem.jpg

The bumper is cut the same on both sides and more measuring and examination shows that the front point on the top of the fender is 1/2 lower on one side than the other. I don't see how it's possible to get this headlight to fit. Any suggestions?

Larry