Visit our community sponsor
Thanks:
0
Likes:
0
-
Electronic led signals
Just want to share a problem I came across. My signals would not work properly when the engine was running. I traced it to the coil wire. When I wired the engine compartment I tried to make the engine harness look neat and I combined the MSD wiring with the main harness. The coil wire was inducing electricity and interfering with the electronic flasher causing the signals not to work properly.
-
Seasoned Citizen
Good catch. You can sometimes eliminate the induction issue by twisting the pair of wires. In aviation it is common to use twisted pair & shielded wires to resist interference by electrical noise. Aircraft Spruce is a good source for twisted pair shielded wire if you want to try it on your coil wires & re-run them in a common loom.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor