Spindle reaming and cutting just checking - advice please

[Honest Ernie]

Hello Everyone. Honest Ernie here with his cobra build #10314

Just a quick question to make sure I am doing this right and not cutting off something I will need latter ha ha. I am doing what I can while I wait for my POL to show up.

2015 IRS spindle

So I am reaming out the countersunk hole out to 5/8.

Cutting off the ear as shown in the attached photo.

Is this correct. Thank you in advance on the newbie question.

Honest Ernie

[michael everson]

Yes you are correct. Its not a fussy cut either. Just stay out of the countersunk area.
Mike