Midwest Classic Insurance

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 5 of 5

Thread: How many of you...

  1. #1
    Banned
    Join Date
    Jun 2016
    Posts
    315
    Post Thanks / Like

    How many of you...

    ...forgot or didn't know you need to remove the output shaft race from the tail-housing when you do the 2WD conversion?

    IMG_20170318_122653234.jpg

    That bad boy has been bouncing around back there for 500+ miles.

    It's a slip fit into the bore that's above the main shaft, so if you didn't remove it, it's probably fallen out and loose.

  2. #2
    Junior Member
    Join Date
    Jan 2017
    Location
    NYC
    Posts
    24
    Post Thanks / Like
    I've done that, but luckily realized it before I installed the trans.

  3. #3
    Banned
    Join Date
    Jun 2016
    Posts
    315
    Post Thanks / Like
    I made sure to do it on the new trans

    I should have known better with all the times I've had a 5MT apart but I never even thought of it until I pulled the block off plate off. Always freaked me out a bit how loose those are "pressed in" from the factory.

  4. #4
    Junior Member
    Join Date
    Jan 2017
    Location
    NYC
    Posts
    24
    Post Thanks / Like
    Happens to the best of us.

  5. #5
    Member
    Join Date
    Jul 2013
    Location
    Tallahassee, Florida
    Posts
    50
    Post Thanks / Like
    I did not see anything in the instruction manual about this. I am right at this point, thanks a million for this information.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Breeze

Visit our community sponsor