I have a 95 Bellhousing with my T5, so my driveshaft needs to be a little shorter than standard.
Does anyone have one laying around? Send me a PM
thanks,
Dave
Visit our community sponsor
I have a 95 Bellhousing with my T5, so my driveshaft needs to be a little shorter than standard.
Does anyone have one laying around? Send me a PM
thanks,
Dave
Dave
Mk 3.1 - #6882 - 5.0L 302 - FiTech EFI - 3-Link - 3.08 Ratio - 15" Wheels
Greenhorn and doing the best I can
My photos are at: My Flickr acct
Videos are at: YouTube Videos
Dave,
Can't help out with the driveshaft but knowing that you have done some mix-n-match with parts want to confirm that you also have an SN95 T5. You can bolt a Fox configuration T5 to a SN95 bell but the input shaft isn't long enough to engage the pilot bearing.
Jeff
Yes, thank you. It is the T5 that was matched to this bell housing from a Gt95
Dave
Mk 3.1 - #6882 - 5.0L 302 - FiTech EFI - 3-Link - 3.08 Ratio - 15" Wheels
Greenhorn and doing the best I can
My photos are at: My Flickr acct
Videos are at: YouTube Videos