20170517_151950.jpg20170517_152102.jpg
I just installed the rear exhaust on the 33. I found that the rear tail pipes are too short to allow the tips to reach the rear of the body. In fact, the passenger side is 2 inches shorter than the driver. This difference begins at the headers and cannot be adjusted since these newer systems use all ball and socket joints. No slip pipes leave no room for adjustment. The tips are held on with band clamps that are just 1 inch wide so no slack there either. Anyone seen this issue before and have a solution other than visiting a stainless steel welder person for a longer extension? How hard would it have been to leave six inches of extra pipe on these things to allow for fine tuning?