Will this be a problem?

[Jacob]

I am concerned that the hose filler location will not be the highest point in the system. Will this be a problem? The picture shows the hose tilting downward but when connected to the top of the radiator outlet that hose will be nearly parallel to the ground. Any help is appreciated.

[IMG][/IMG]

[AC Bill]

What hose are you using from the T-filler, onward to the rad?
You can see here how I cut the hose shorter, so that the T filler was still the highest point, although not by a lot. Never had an issue with burping or air in the system.

[Jeff Kleiner]

Jacob,
It will be impossible to fully fill the system (water doesn't flow uphill ) and purge air from the system. Bill shows a good example.

Jeff

[Jacob]

What hose are you using from the T-filler, onward to the rad?
You can see here how I cut the hose shorter, so that the T filler was still the highest point, although not by a lot. Never had an issue with burping or air in the system.

thanks, I can either cut the hose and install the T making it highest, or get another 90...think I'll go with another 90, to be neater. I was gonna make up the remainder of the hose to the radiator inlet using the corrogated SS tubing from FFR.