Boig Motorsports

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 7 of 7

Thread: Front Lower Control Arm Lenth

  1. #1

    Join Date
    Nov 2016
    Location
    Petaluma, CA
    Posts
    345
    Post Thanks / Like

    Front Lower Control Arm Lenth

    Can anyone tell me the length of the pin drive front, lower control arms as compared to the standard front lower control arm measuring from the grease fitting to the center of the mounting hole? Is there an easier way to tell the difference between the two? Thanks

  2. #2

    Join Date
    Feb 2011
    Location
    Norton, MA USA earth
    Posts
    3,325
    Post Thanks / Like
    I think the pin drives are 13 and the regular are 15.
    Mike

  3. #3
    Not a waxer Jeff Kleiner's Avatar
    Join Date
    Feb 2011
    Location
    Bloomington, Indiana
    Posts
    8,003
    Post Thanks / Like
    Standard width are 15" overall and the gussets where the legs of the "A" meet the bushing sleeves are to the inside.

    Pin drive width are 13" overall and the gussets where the legs of the "A" meet the bushing sleeves are to the outside.

    Jeff

  4. #4

    Join Date
    Nov 2016
    Location
    Petaluma, CA
    Posts
    345
    Post Thanks / Like
    Jeff, thank you so very much. Is there any chance you can send me a picture to help me clarify the measurement? I should have the pin drive versions. Thanks

  5. #5
    Not a waxer Jeff Kleiner's Avatar
    Join Date
    Feb 2011
    Location
    Bloomington, Indiana
    Posts
    8,003
    Post Thanks / Like
    For you and anyone else who may need the info:

    Pin drive width



    __________________________________

    Standard width



    __________________________________


    Cheers,
    Jeff

  6. #6

    Join Date
    Nov 2016
    Location
    Petaluma, CA
    Posts
    345
    Post Thanks / Like
    Thanks Jeff. Mine are certainly closer to 13" than 15". I am guessing the UCAs are the same for both. Joel

  7. #7
    Not a waxer Jeff Kleiner's Avatar
    Join Date
    Feb 2011
    Location
    Bloomington, Indiana
    Posts
    8,003
    Post Thanks / Like
    Yes, the uppers are the same for both standard and pin drive width however the spindle adapters are different.

    Jeff

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Brown County Customs

Visit our community sponsor