Visit our community sponsor
Thanks:
0
Likes:
0
-
cockpit sheetmetal
Trying to figure out if I messed up position of my rear sheetmetal. I drilled and riveted it by the attachments and floor but my harness strap cutouts are partially covered from where sheetmetal was positioned from factory five, has anybody else experienced this? Holes are covered about 1/4 of the hole.
-
Senior Member
Originally Posted by
feadam
Trying to figure out if I messed up position of my rear sheetmetal. I drilled and riveted it by the attachments and floor but my harness strap cutouts are partially covered from where sheetmetal was positioned from factory five, has anybody else experienced this? Holes are covered about 1/4 of the hole.
That's the way they're supposed to be. The straps rest on the chassis tube vs. on the edge of the cutouts.
Build 1: Mk3 Roadster #5125. Sold 11/08/2014.
Build 2: Mk4 Roadster #7750. Sold 04/10/2017.
Build Thread
Build 3: Mk4 Roadster 20th Anniversary #8674. Sold 09/07/2020.
Build Thread and
Video.
Build 4: Gen 3 Type 65 Coupe #59. Gen 3 Coyote. Legal 03/04/2020.
Build Thread and
Video
Build 5: 35 Hot Rod Truck #138. LS3 and 4L65E auto. Rcvd 01/05/2021. Legal 04/20/2023.
Build Thread. Sold 11/9/2023.
-
Senior Member
Yup, that's normal. Here's is mine.
-
Senior Member
Clecos look so cool. I might just try to find a way to use them around the house. Surely, something needs to help in place via a 1/8" hole.
FFR MK4 Complete Kit #8952
Build Thread
Bodywork Thread
3 Link Rear Suspension, Gordon Levy 347 SBF with T5
First start Feb 20, 2017, First Go Kart March 5, 2017, Registered & Title April 25, 2017
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor