Can any of you recommend the best way for me to get my lap belts the proper length to reach through the side access slots in my bucket seats? My (cheap) 5-point harness from ebay has slide buckles that are tricky to fit through the slots to begin with, and then they end up interfering with the slots making it impossible to adjust them. Do I have to get custom lengths made up? Should I cut the slots in my seat bigger? Is there a safe way to extend what I have somehow?

I was also planning on using my OEM subaru seatbelts, but have run into a similar problem on the receptacle side...the stock belts wont reach up far enough form the floor mounting points. I have a 12" extension I am going to try, but it might be too long. I may need 6" or so. I dont know why this has been such a frustration to me, but it is one of those little projects that I ran into trouble with and have now been putting off for months! Gotta get them done!

Any suggestions are appreciated! I'll try to post some pictures a little later.

Thanks all,

Ben