Gen II Hood Louvers Now Available!

[VRaptor SpeedWorks, LLC]

Well, after a few different versions, I finally have a finalized design. Vidal has kindly been my guinea pig and helped me get these to properly fit his hood and provide pics. These are meant to install/bond onto the bottom side of the hood after cutting the "flange" out and leaving the nice, gel-coat radius that is already moulded into the hood, so minimal bodywork is needed to install them. Here they are taped into position on Vidal's GTM:

















Based on looking at the fg inserts that FFR provides for this area, I'm guessing these will flow about 10 times more air.....whether or not this is an issue, I don't know, but I can't see any problems with evacuating a significant increase in hot air from under the hood.



Price will be $119 plus shipping. As with all of my other louver products, they will be made from .080" alum and be shipped flat. They are easily formed and assembled by hand. Shoot me a PM or email thru my contact info on my website if you are interested in ordering these. Thanks!

[The Stig]

That looks good Shane.

[riptide motorsport]

Very nice!

[VRaptor SpeedWorks, LLC]

Thanks guys!

[VD2021]

Another outstanding product.

Though I may be a bit partial.....