Exactly what the title says i have the original steering wheel would like to put probably a 13 inch wheel on her! To give me a little more room. I have the Russ Thompson Turn Signal adapter any ideas?
Thanks
jim
Visit our community sponsor
Exactly what the title says i have the original steering wheel would like to put probably a 13 inch wheel on her! To give me a little more room. I have the Russ Thompson Turn Signal adapter any ideas?
Thanks
jim
Preferably something that bolts right up.
I went with a 330mm Nardi wood steering wheel. Not a direct bolt-up unless you also go with the NRG quick release mod that several (including me) have done. Then the Nardi, Momo, and Sparco wheels bolt right up to the NRG hub.
I have a few posts in my build thread about the whole setup, but here's the post with the finished wheel with QR.
Last edited by JohnK; 10-24-2020 at 02:42 PM.
MkIV Roadster build: Gen 2 Coyote, IRS, TKO600. Ordered 10/24/18. Delivered 1/29/19. Engine installed 8/8/21. First start 9/12/21. First go-kart 9/17/21. Off to paint 4/11/22. Back from paint 12/30/22. Build thread here.
I changed to the leather covered one from finish line, it's smaller, a smaller wheel makes it harder to turn if you don't have power steering.
FFR8237 Donor build 89 GT , MK 4 , T5 , 17 " hallibrands 9" front 10.5 rear ,4×4 headers stainless mufflers, dual chrome roll bars, coil overs all 4,A/C and heater , soft top, 3:55 gears.
I went with a 12" custom wheel from Moto Lita. They made it with the Cobra hole pattern. They'll make a custom variant of their standard products, just contact them in the UK via their website.
20190618_095703_1560866463419_resized.jpg