ReinCarNation

Visit our community sponsor

Search:

Type: Posts; User: 1932

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Got the ac lines and wiring done, well check for...

    Got the ac lines and wiring done, well check for leaks. The water lines for air to water coolers are are done and ready to check. working on last part of fuel line. So we are getting down to turbo...
  2. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Gas filler, i never liked the air vent-did not...

    Gas filler, i never liked the air vent-did not work! So with my two new tanks i put vents in all the tanks106978 looks good but did not like angles on fittings, so cut it up and remade...
  3. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Well after some redo's got the in and out piping...

    Well after some redo's got the in and out piping done. 106880106881106882106883
    Now to get the filler tube and vents from tanks done.
    Yes the back side looks off, but had them looking very good...
  4. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Yes

    Yes
  5. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Yes, some things like the drive line will be a...

    Yes, some things like the drive line will be a lot of work to get off and on!
  6. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Heat exchanger for air to water cooler and...

    Heat exchanger for air to water cooler and condenser for ac.106617106618
    Mounted the water pumps for air to water cooler106619
  7. Thread: Simpson Seatbelts

    by 1932
    Replies
    22
    Views
    1,517

    Had seat slot put in seat for proper fit and put...

    Had seat slot put in seat for proper fit and put bolt under seat into the metal between small tubes
  8. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Got the fuel pump mount made and pump on106390...

    Got the fuel pump mount made and pump on106390 With some other shots from under car.106391106392106393106394
  9. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    12 an houses from top tank to the two bottom...

    12 an houses from top tank to the two bottom tanks.106375106376
  10. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Had to make a header tank because the first way i...

    Had to make a header tank because the first way i was going to plume tanks did not work. 106372106373
    Still learning to TIG, the first tank i used heaver aluminium and MIG welded then TIG for...
  11. Replies
    14
    Views
    590

    Move top of grill out, turn bolts around so nuts...

    Move top of grill out, turn bolts around so nuts are to fan, cut bolt to just go to end of nut. You can also trim fan housing so nuts clear.
  12. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Tanks are in, and now to magic pluming! Takes...

    Tanks are in, and now to magic pluming! Takes more fittings to do three tanks.106084In , out vent and return. Using ptfe hose and fittings.
  13. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Got all fittings welded on tanks and 25 PSI...

    Got all fittings welded on tanks and 25 PSI tested. Hope to fix tanks in and get pluming done!
  14. Replies
    24
    Views
    1,896

    The grate thing about these cars is the different...

    The grate thing about these cars is the different ways to do things.106058106059
    Do not cut off top posts, it kills battery!
  15. Replies
    3
    Views
    229

    You have to move the lid all a round to get the...

    You have to move the lid all a round to get the best overall fit, do not cut all on top or bottom. Or the sides wont fit. On the top make sheer that lip and body are flat to get the best fit. Hope...
  16. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Ok this a little bigger than the other tank, but...

    Ok this a little bigger than the other tank, but it is TEN usable gallons! So if we look at nine gallons each gives me eighteen gallons + top tank!
    Extra weight is low and just in front of rear...
  17. Replies
    11
    Views
    347

    I think it is the purple wire.

    I think it is the purple wire.
  18. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Got the two tanks done-psi test to 20-, now need...

    Got the two tanks done-psi test to 20-, now need to get the pluming going.105486105487105488Seven to eight gallons each.
  19. I got 3 inch oval- custom - inside of frame. It...

    I got 3 inch oval- custom - inside of frame. It was a lot of work, but fun. 104998104999
  20. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Had to put battery in to pump out tank, so i put...

    Had to put battery in to pump out tank, so i put oil in engine and turned it over for oil psi-- had leak at remote filter, yes hard to get at. Put new male fitting and hoses
    on now all good.
    Got...
  21. Thread: Duff33 Build

    by 1932
    Replies
    158
    Views
    24,034

    speedway has some.

    speedway has some.
  22. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Done with bars104638104639104640104641104642 On...

    Done with bars104638104639104640104641104642
    On to removing gas tank, and making two more to go under tank, have to plum all tanks together.
  23. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Got the back bars welded and cleaned...

    Got the back bars welded and cleaned up104532104533104534
    These will be the front hing, waiting for hinges for rear.
  24. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    working on making the door space stronger for...

    working on making the door space stronger for others bumpers104490104491104492
    Well have a hinged bar from this to a hinge that well be welded to front bar. will be about 25 inches off road.
  25. Thread: Toms 33

    by 1932
    Replies
    425
    Views
    77,514

    Working slowly on pluming and pulling seats and...

    Working slowly on pluming and pulling seats and water fall to get tank out. Going to make two tanks under top one and have to plum them up, so need to weld bungs into bottom outside of top tank. I...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

Replica Promotions

Visit our community sponsor