Fuel Safe Systems

Visit our community sponsor

Search:

Type: Posts; User: DS9941

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    685

    Located in Ohio 104165

    Located in Ohio

    104165
  2. Replies
    1
    Views
    685

    Factory Five #953 33 Hot Rod for Sale

    Took delivery 9/21/2016 , finished 10/19/2017, Factory Five #953
    Drove it to several car shows summer of 2018, New build, only 350 miles
    Black exterior, Black interior
    355 small block chevy built...
  3. Thread: Bobs 33 build

    by DS9941
    Replies
    53
    Views
    3,691

    looking good

    looking good
  4. Replies
    60
    Views
    9,801

    Looks good, a lot of great pictures

    Looks good, a lot of great pictures
  5. Thread: Tampa33Build

    by DS9941
    Replies
    45
    Views
    5,307

    Looks great

    Looks great
  6. Thread: Car cover?

    by DS9941
    Replies
    21
    Views
    1,222

    Looks like good quality, would be nice if it fit...

    Looks like good quality, would be nice if it fit better
  7. Replies
    11
    Views
    558

    I just polished mine for now, it looks pretty...

    I just polished mine for now, it looks pretty good, not sure what i want to do with it
  8. Replies
    11
    Views
    354

    I didn't wrap anything, I just put shield between...

    I didn't wrap anything, I just put shield between muffler and floor. Floor gets a little warm but not too bad
  9. Replies
    23
    Views
    1,357

    Keep up the good attitude, you can do it

    Keep up the good attitude, you can do it
  10. Thread: Duff33 Build

    by DS9941
    Replies
    152
    Views
    22,359

    I was wandered what i would do if the trunk would...

    I was wandered what i would do if the trunk would bind and i can't get it opened, so i bolted the cover for the hole directly below the latch from the outside with rivnuts. So now i can crawl under,...
  11. Replies
    31
    Views
    1,547

    Looks like your getting ready to have a lot of...

    Looks like your getting ready to have a lot of fun. I built a 33 hot rod, I would like to build a Mk4 someday
  12. Replies
    20
    Views
    1,181

    I used the simpsons but when i drive it I only...

    I used the simpsons but when i drive it I only use the lap part but they look cool

    103540
  13. Thread: Ride Height

    by DS9941
    Replies
    10
    Views
    1,116

    Yes, measure from 4 corners but the 4 1/2" and 5"...

    Yes, measure from 4 corners but the 4 1/2" and 5" was way to low for mine. I think i am at 6" rear and 5 1/2" front

    103539
  14. Replies
    9
    Views
    390

    Do you have the correct transmission mount and...

    Do you have the correct transmission mount and spacing. I had to space my trans mount up a little to get everything to work
  15. After sanding and polishing mine goes in and out...

    After sanding and polishing mine goes in and out ok with a dead blow you just have to go evenly, not the greatest roll bar but better than none at all
  16. Replies
    12
    Views
    2,950

    For the hardtop on the back of the body I put my...

    For the hardtop on the back of the body I put my rivnuts into an aluminum plate all the way across the back under the body so my studs for the top go through the fiberglass body and thread into the...
  17. Replies
    8
    Views
    491

    Yes, I also had to trim most of the hood up to...

    Yes, I also had to trim most of the hood up to the body line to get it to fit103538
  18. Thread: Shifter 700r4

    by DS9941
    Replies
    3
    Views
    594

    I have a 700r4 and I went with the Lokar tale...

    I have a 700r4 and I went with the Lokar tale mount (Lokar ATS6700ETMM) 103536
  19. Replies
    10
    Views
    901

    I used the little LED strip that came with mine,...

    I used the little LED strip that came with mine, I cut it in half and stuck 1 on each side under the dash lip. It works well.
  20. There should be some wires that you are not using...

    There should be some wires that you are not using that you could use for something else, (radio, radio memory, heater, electric choke, etc.) I did that and just remarked the wire for what i was using...
  21. Replies
    10
    Views
    1,018

    I made 1 "U" shaped cut at top middle of tunnel...

    I made 1 "U" shaped cut at top middle of tunnel by firewall so I could get tunnel in and out, it worked out good. I also ran my wiring on top of trans (in loom) then down by the tailshaft to the...
  22. Replies
    417
    Views
    134,152

    Sticky: Darrin Sparks #953 Delivered 9/21/2016 , Finished...

    Darrin Sparks #953 Delivered 9/21/2016 , Finished 10/19/2017 Lebanon, Ohio

    103359
Results 1 to 22 of 22

Levy Racing

Visit our community sponsor