Looking for plug and pin kit

[Shoeless]

Hey guys,

I've done some looking but am having trouble locating a plug and pin set for the plug that goes into the in tank fuel pump setup pictured below. I have the Lingenfelter high-flow pump, but should be the same as the OEM connector.

Anybody know where I can source one of these plug and pin sets?

[wallace18]

online Corvette salvage yards will have it.

https://corvettesalvage.com

[beeman]

Not sure, this Fuel Pump Adapter Harness (FPAH-001) by Racetronix looks like the same pigtail...

[Shoeless]

Not sure, this Fuel Pump Adapter Harness (FPAH-001) by Racetronix looks like the same pigtail...

That looks darn close, I'll have to give them a call and double check. If this one actually fits, it looks like it's a GM Delphi / Packard - 4 way square metripack 150 male O2 connector Kit. Found it on Ballinger Motorsports for $6.99 after reading the details on the Racetronix website.

https://www.bmotorsports.com/shop/pr...roducts_id/868

[KGTM]

This is what you need.

https://www.racetronix.biz/product.asp?ic=iph-008.

I think The metripack 150 is too small, is is closer to 280 than 150 due to higher current needs.

[Shoeless]

This is what you need.

https://www.racetronix.biz/product.asp?ic=iph-008.

Now that looks exactly like the plug that goes from the internal flange side to the pump itself. I just took it apart again to verify and sure enough that's the plug on the inside. Now I just need to source some new pins. Thanks for the help KGTM!!

[KGTM]

no problems.

I used the OEM cable just pictures and source the mating end that it is easier to get.

20191225_160352.jpg20191225_160313.jpg

[HardRocker]

Powerandsignal.com and mouser electronics have the pins and plugs. One of the C5 manuals will spec the connector and pin type.