My Daytona Coupe Build... Ten Years in the Making

[Carlos C]

Spent this afternoon running all 10 zones on my irrigation system, making a diagram of where they all are (since neither my builder, nor the contractor who installed the system bothered to do this), recording the spray pattern of the sprayers and the rotational degree of the rotors, and checking for any substancial leaks. Good news: no leaks; bad news: I have to repair/replace two rotors. Then I worked on my bike. By the time I was done, I didn't feel like doing anything else. At least, I still made some progress prepping more of the donor parts at work. Hope to get the rear end and some other parts painted in the next few days.

I found a metal supplier in Clearwater. I'll be buying a sheet of 16-gauge hot-rolled steel next week, to make an oven extension box for powder coating bigger parts.

Carlos