Visit our community sponsor
Thanks:
0
Likes:
0
-
Member
Originally Posted by
FFRSpec72
But the angle where the upper and lower meet will be off now since you pushed it back
I did not do a good job of explaining. What I did, after I set the lower piece back a couple of inches, was to lower the upper piece until it intersected the lower correctly. It was about 4 inches lower then. I then cut the overhang off so it would look right, and then I used the cutoff piece to extend the top of the upper firewall piece.
So, really, the difference is that the flat shelf is about 4" lower than before, and the lower part around the fuel tank is not so deep.
Thanks!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor