Visit our community sponsor
Thanks:
0
Likes:
0
-
Senior Member
Sedan seat belt hack: tilt sensor delete
No matter how I fiddled with them, I couldn't get my sedan donor seat belt reels oriented so the tilt sensors wouldn't lock up. So I removed the sensors. Now the belts work great. The lock up feature due to sudden jerks on the belt is unchanged.
I took the driver's side reel off the car to delete the sensor, but I did it on the passenger side with the reel still attached.
To open the the reel, pop the three plastic pins that secure the transparent cover
20141116_113918.jpg
The cover should pop off, I pried it gently with a flat head screw driver. Don't turn it over or the gears will fall out. They're easy enough to drop back in though.
20141116_112958.jpg
20141116_113009.jpg
The tilt sensor is the orange part in this pic, although it's green on the 818 passenger side (formerly WRX driver side) belt
20141116_113029.jpg 20141116_113114.jpg
It easily slips out.
Make sure the gear is in the right position . . .
20141116_114323.jpg20141116_114811.jpg
. . . before you replace the cover.
20141116_115545.jpg
Test the belt a few times to make sure everything is replaced properly, then pop the plastic pins back in and you're done. Now the belt will work with the reel in any orientation
Last edited by Buzz Skyline; 11-17-2014 at 10:24 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor