received my halos and glue from retrofit source.
had to sand off the back of the reflectors to make the HID's fit. The reflector is too thick for the HID's.
Standard reflector
reflector.JPG
Sanded reflector. I took off about 0.25 in.
sanded reflector.JPGsanded reflector2.JPG
angle from bottom of reflector is not square so you need to use an angle tool to check the correct angle when you sand it. I used a belt sander..
reflector not square.JPGreflector angle.JPG
Installed the Halos.. They are white when off, so won't look the greatest when lights are off. But when the lights are on they perform like DRL's and turn orange when signalling to turn (if you want)
Here they are installed.
halo installed.JPG
I wired them in with a small copper wire to hold in position attached to the shrouds. and electrical wire runs back through the projector and out the reflector in the back. I used the hole where the low beam shroud was attached.
halo wired in.JPGhalo wiring.JPG