Forte's

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: DIY Bungee Cord Mounts

  1. 12-16-2014, 11:10 PM #1
    2FAST4U
    2FAST4U is offline
    Senior Member 2FAST4U's Avatar
    Join Date
    Feb 2011
    Posts
    1,006
    Post Thanks / Like

    DIY Bungee Cord Mounts

    Started with 3/8x1-1/2 SSTL fender washers and opened up the ID to 9/16". I made a drawing on my computer, printed it out, and then tapped it to a piece of wood. I stacked the washers and bolted them in place with a bolt. I mounted the jig in my drill press and proceeded to drill three mounting holes 120 deg apart. Drilling the mounting holes with the washers stacked ensures the two pieces are identical. I decided not to countersink the holes. Tomorrow I'll sand them with 400 and then 600 grit wet sandpaper for a brushed look





    Reply With Quote Reply With Quote
  2. 12-17-2014, 11:16 AM #2
    David Hodgkins
    David Hodgkins is offline
    Administrator David Hodgkins's Avatar
    Join Date
    Feb 2011
    Location
    Corona del Mar, CA
    Posts
    6,065
    Post Thanks / Like
    Blog Entries
    7
    Smart! Nice detail...


    FFR 5369 Pin Drive, IRS, Trigos, Torsen, Wilwoods, FMS BOSS 302 "B" cam , Mass-flo. CA SB100 (SPCN) Registered
    Delivered 4/23/06. "Finished" 4/2012 (still not done!)

    Reply With Quote Reply With Quote
  3. 12-19-2014, 08:13 PM #3
    2FAST4U
    2FAST4U is offline
    Senior Member 2FAST4U's Avatar
    Join Date
    Feb 2011
    Posts
    1,006
    Post Thanks / Like
    Installed
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Brown County Customs

Visit our community sponsor