BluePrint Engines

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  2
Results 1 to 2 of 2

Thread: Carbon Fiber Dash cutout

  1. #1
    Joynt Venture's Avatar
    Join Date
    Oct 2019
    Location
    Cape Coral, FL
    Posts
    27
    Post Thanks / Like

    Carbon Fiber Dash cutout

    Working on the CF dash. In following the directions on the FFR site under Carbon Fiber Dash, the template for the dash I received is opposite from the printed directions. Their picture and printed directions match, however the template I received is different. When I look at the template, the marking for the steering is shown as: MK1/2 to the left, and MK3/4 to the right. The printed directions show MK 3/4 left and MK 1/2 to the right. If I follow the template and positioning if the large gauge to the left of the steering, it leaves +/- 3/4" between the steering cutout and the gauge. I note larger gaps in pictures of the Carbon Fiber dash that I have seen on the internet.Printed Dash Instructions.jpgDash Template.jpg
    Last edited by Joynt Venture; 12-05-2020 at 09:35 AM.

  2. #2
    Joynt Venture's Avatar
    Join Date
    Oct 2019
    Location
    Cape Coral, FL
    Posts
    27
    Post Thanks / Like
    Just heard from Dan at Factory Five. Apparently I received the wrong template. Great service as always from FFR!

  3. Likes 65 Cobra Dude, toadster liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Brown County Customs

Visit our community sponsor