I have a question for anyone using the hood pins that were supplied with the kit. In some photos of the 818C I can find on the interwebs, there are two sets of hood pins being used to keep the hardtop mounted. One set clearly has a mounting point to the frame halfway down the rear quarter panel. The second sent I see in photos is being used right at the point where the hardtop meets the bumper. I am guessing that those hood pins are being attached to the bracket that was being used to attach the bumper and the rear quarter panel. You can see the brackets (one on each side) I am referring to in the first linked photo. I am not currently using any spacers to attach that bracket. I think the manual makes mention of using spacers for attaching the rear panel when building the 818S. Does anyone have a picture of how they are attaching the hood pin to this bracket? I think spacers would have to be used since without the spacers, it sits too high and there would not be enough room to attach the hood pin.

https://photos.app.goo.gl/MKFyRaPFjfg8AXhW8

Link to John Gamble's 818 photo showing the location of the most rearward hood pin.
https://statics.wheelwell.com/u/52e9....jpg?width=900