Quote Originally Posted by cv2065 View Post
Hey Dave. I'm at this point in my build. Did you find that the screw fitting with the nut on the end of it (in the above picture) hit some of the splines instead of that bare spot in between splines on the shaft when bottomed out? If I tighten it down, just wondering if it would damage the splines in the event that I need to take it apart again.

Also, you have the exact same PS from FFR that I do. Do you remember how much threading you had left on each tie rod end when the rack was centered and hubs aligned straight ahead?
I honestly can't recall how far the splines extended on the PS rack, but I doubt that the set screw will cause any damage to the splines unless it is overtightened.