Boyd Tank Install Question

[kcarlasc]

I put my Boyds tank and noticed the bottom tabs are point up a bit.. anyone have this? And what did everyone use to mount the tank with on the bottom. Planing on using rivnuts on the top..

[wallace18]

I put foam tape on bottom of tank area and used S/S button heads screws through the floor. Post #64

http://thefactoryfiveforum.com/showt...ot-s-818-Build

[kcarlasc]

Thanks... is that a custom piece of aluminum for the firewall? Where your tabs bent up?

[wallace18]

Thanks... is that a custom piece of aluminum for the firewall? Where your tabs bent up?

I modified the FFR front firewall and made my own custom rear one. The tabs were just like in the photo.

[Wayne Presley]

I just put on in. The tabs are at 90° to the face of the tank. I used a dead blow hammer to bend them parallel with the bottom of the tank.

[kcarlasc]

Thanks Wayne... I did the same thing just yesterday!!!

I just put on in. The tabs are at 90° to the face of the tank. I used a dead blow hammer to bend them parallel with the bottom of the tank.