Need help with Rear Brake Caliper

[Tex2131]

Can anyone tell me how to install the two clips at the bottom of the picture? Want to make sure
I get this right. Thanks, Don
Caliper.jpg

[JoeAIII]

They go on either side of the bracket where the tabs on the side of the pads ride in them

They are anti rattle clips and keep the pads from rattling against the bracket there by applying a little bit of pressure on the guide tabs

[Tex2131]

Thanks! That helped me figure it out. Don

[japollon]

Can someone show a picture of their installation?

[Joee]

Can someone show a picture of their installation?

Go here

https://turn5.scene7.com/is/image/Turn5/386333?$enlarged810x608$

[Itchief]

I’m not sure if this will help

EBDFCE89-A04B-444F-AA03-9E86B05AE59F.jpeg

Tex

If you are building a complete kit with the willwood petal box and the Ford GT brakes front and rear I would replace the stop tech brake pads with a more aggressive pad

The stop tech pads require a LOT of pressure to lock up the brakes and make a lot of brake dust

Several vendors made a more aggressive pad I installed EBC blue stuff pads and they made the car have a lot better brake response

Hope you have a great time building the car

Rick