BluePrint Engines

Visit our community sponsor

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Do I re use this pinion flange?

  1. #1
    Senior Member Yama-Bro's Avatar
    Join Date
    Jul 2012
    Location
    Kearney Nebraska
    Posts
    847
    Post Thanks / Like

    Do I re use this pinion flange?

    I took this off my 8.8 straght axle. Do I re use this flange, do I need to get a different one, or does one come with the kit?

    Thanks!

    Started dreaming of a Cobra around 1987
    Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
    Click here for my build thread
    Serial #9158
    Design Engineer at BluePrint Engines

  2. #2

    Join Date
    Feb 2011
    Location
    Norton, MA USA earth
    Posts
    3,326
    Post Thanks / Like
    reuse it
    Mike

  3. #3
    Senior Member AC Bill's Avatar
    Join Date
    Feb 2011
    Location
    Vancouver Island BC Canada
    Posts
    1,877
    Post Thanks / Like
    In case you need any, here are some instructions on the 8.8 rear end. (You'll need an in/lb torque wrench for figuring out the pre-load, after replacing the crush washer).

    https://performanceparts.ford.com/do...htM-4209-8.pdf
    Last edited by AC Bill; 02-09-2018 at 07:06 PM.

  4. #4
    Senior Member Yama-Bro's Avatar
    Join Date
    Jul 2012
    Location
    Kearney Nebraska
    Posts
    847
    Post Thanks / Like
    Quote Originally Posted by michael everson View Post
    reuse it
    Mike
    Thanks! I will.

    Quote Originally Posted by AC Bill View Post
    In case you need any, here are some instructions on the 8.8 rear end. (You'll need an in/lb torque wrench for figuring out the pre-load, after replacing the crush washer).

    https://performanceparts.ford.com/do...htM-4209-8.pdf
    Those are good instructions. Thanks!
    Started dreaming of a Cobra around 1987
    Purchased Complete Kit 6/9/2017, Delivered 9/4/2017, Rolling Chassis 3/30/2018, Engine Dyno'ed 3/4/2022, Engine installed 8/27/2022
    Click here for my build thread
    Serial #9158
    Design Engineer at BluePrint Engines

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Stewart Transport

Visit our community sponsor