Anyone dong a ride height greater than 4 1/2"? Is this even possible? If so, what is your ride height? These bones might find it easier to get in and out of a higher riding car.
Not an 818 builder. But similar setup in other builds that I'm familiar with. How much higher do you think would make enough of a difference? Aside from looking a little wonky, not sure the suspension design is intended to be jacked up too much. Would sure need to have the alignment completed at whatever height you use. Also, I suspect it would be easy to be near the top of the suspension travel if too high. Just not sure it's a great idea to be honest.
Build 1: Mk3 Roadster #5125. Sold 11/08/2014. Build 2: Mk4 Roadster #7750. Sold 04/10/2017. Build Thread Build 3: Mk4 Roadster 20th Anniversary #8674. Sold 09/07/2020. Build Thread and Video. Build 4: Gen 3 Type 65 Coupe #59. Gen 3 Coyote. Legal 03/04/2020. Build Thread and Video Build 5: 35 Hot Rod Truck #138. LS3 and 4L65E auto. Rcvd 01/05/2021. Legal 04/20/2023. Build Thread. Sold 11/9/2023.
I'm at about 5" and everything seems to work well. Not sure how much difference half an inch makes for getting in and out though. There isn't much room to go higher then that on my car. In my opinion the S isn't too bad to get into...a bit tougher to get out of, but once you have done it a few times it's not bad.
Thanks: 
Likes: 
Reply With Quote
