Shark92651's MK4 Coyote Build #9327 - Graduated!!

[shark92651]

The stock Wilwood pedal pads weren't really working out for me and I wanted a bit more room to reach my dead pedal. After seeing what others had done I decided I wasn't crazy about the look after cutting them down so I decided to order the bolt on AC Cobra pedals from Mike Forte. The pedals are a little too thick for the rubber inserts to hold properly in place so I used a couple drops of super glue under each one and attached the center cover with a bit of leftover silicon caulk. I like the look and feel of these pedals, they are quality parts.

[Cruzzz]

Looking good! I also installed the Forte billet pedals. Nice product. Even with them the brake and gas pedal were a little too close so I move the brake and clutch pads over by using only the right most screw holes in the pads and the left most holes in the Wilwood arms. Very solid and much better spacing.