2017 rf harness,vintage guages, blue print 306 ford with sniper efi wont start. hand held monitor for efi is showing no rpm signal (wont sync with ecu). i connected grey wire from distributor to rf coil tach wire but no go. any suggestions?
Visit our community sponsor
2017 rf harness,vintage guages, blue print 306 ford with sniper efi wont start. hand held monitor for efi is showing no rpm signal (wont sync with ecu). i connected grey wire from distributor to rf coil tach wire but no go. any suggestions?
Did you connect +12V to the coil?
My Build Thread: http://thefactoryfiveforum.com/showt...ter-Build-9754
(Most viewed Roadster build thread on this forum!)
Delivered: 6/17/2017
First Start: 12/30/2017
Completed: 12/7/2019
Legal: 1/30/2020
Member of the Mile-Hi Cobra Club
Dave's Cobra YouTube Channel: https://www.youtube.com/channel/UCbk...npK1UZHj4R-bYQ
Agora 1:8 Scale Cobra Build: https://thefactoryfiveforum.com/show...l-Build-Thread
Are you using the Sniper system to control timing? If so, have you set that parameter to "yes" during setup?
That was the problem I ran into when I tried to first start my Terminator system...
John
MK IV Roadster #8631
Ford 302, Holley Terminator EFI, T5z, 3.55 Rear End, IRS, 17” Halibrand Replicas (9” front, 10.5” rear), Nitto 555 G2’s (275/40ZR17 front, 315/35ZR17 rear), Fast Freddie’s Power Steering, F5 Wilwood Brakes, FFMetal’s Firewall Forward, Forte’s Hydraulic Clutch & Throttle Linkage
https://www.ffcars.com/threads/phile.../#post-4776313