Trouble using Compound-302 Stainless Steel Cleaner

[accobra66]

I have a set of Gas-n Go side pipes that I just applied Compound 302 to. I am coming away with a very cloudy finish and I am not sure what I am doing wrong. From what I have read from everyone else this product is very simple to use.

What I did:

1. Applied product in small area.
2. Let product sit between 1-3 minutes.
3. Went over pipes (in direction of grain) with 0000 steel wool.
4. Rinsed off product with a mix of water and dish soap.
5. Rinsed off pipe with water out of the hose.

I went back in a small area and have twice put more product on, let it sit say 3 minutes and rinsed again. Although it seemed to help (marginally) I am still coming away with a cloudy finish.

What am I doing wrong?