Gen 3: Front Harness Routing Question

[Dlirium]

All,

I'm stuck. The front harness that comes with the Ron Francis wiring kit looks like it should come out the drivers Foot box somewhere, but there isn't anything clear in the manuals (Ron Francis or FFR) as to where the recommended exit is for optimal routing to the front headlights, etc. I'm ready to take the engine panels to Powder Coating as soon as I figure out where to punch the hole, but that's where I could use the help of the collective. On the Drivers side, there is an upper frame part that runs to the top of the front shock (the yellow path) and a cross piece that runs diagonally down (the red path). Each requires a different point at which to punch through the foot box panel (either yellow hole or red hole). Take a look at the attached picture.

Part of the problem as that I can't really visualize the final destination of the wires, so I don't know if the upper path or lower path is better. Or maybe you've gone a different direction?

I sure would appreciate any input you may have!!