I was plumbing my FFR radiator to my Coyote engine using the supplied stainless flex hose, adapters, clamps, etc.
Where the upper hose connects to the engine, the plastic neck on the engine has no barb. I am able to get a good fit with the hose and a clamp, but I can just see this thing blowing off when things get hot and under pressure.
Any advise or ideas on keeping the hose from unseating itself.
Second issue, I need a part number or source for the glove box door finger handle. The door fit is too snug to open it with something to pull on.
Thanks for any help.