Guys
I'm wiring my 2015 Gen2 Coyote using the ford controls pack and the supplied Ron Francis wiring harness too. The Chassis Wiring manual talks about a thermostat switch to be installed somewhere on the engine, or in the radiator.
Couple of questions:
1. Is this applicable to the Coyote engine setup ? I already have the orange fan wire from the controls pack connected to my fan. I'm assuming that the engine and controls pack are communicating engine temp somehow ?
2. The Coyote fitment instructions shows installing a temperature sensor on the block then I'm assuming that's just for the dash gauges ?
Any help would be greatly appreciated!
thanks
mark