Thanks in advance for your help. I have a complete kit and just started my build. My upper control arms arrived with the pivot bars upside down. I reversed them so that the grease fittings are facing up. Question number 1 ... can someone look at my attached pics and verify that I got the upper control arms installed correctly? Question 2 ... in the complete kit manual, there is a page for Rough Alignment. The drawing shows the passenger side arm. It mentions the drivers side arm but does not say how the alignment should be set up on that one. The challenge for me is that if I take the drivers side arm and just rotate it 180 degrees from the passenger side (where the clevis bolt on the ball joint plate is toward the front of the car), the clevis bolt on the (drivers side) ball joint plate is toward the back of the car. For the Drivers side, this does not allow me to measure the 6.875" distance from the pivot bolt to the clevis bolt on the front side. Sorry if this is confusing. I did a photoshop drawing of what I am talking about. It is attached. My guess is that for the drivers side, I can only measure the distances from the pivot bolts to the grease fitting. Thanks again. Dan
20180818_152734_resized.jpg20180818_152748_resized.jpg20180818_152802_resized.jpg20180818_152844_resized.jpgUpper A Arms.jpg