Was watching the FFR Video #9 on fuel tank install. They recommend 'Seal All' for the rubber o-rings. I've never used a sealant like that on o-rings...only motor oil or vasoline. Anyone use the stuff?
Visit our community sponsor
Was watching the FFR Video #9 on fuel tank install. They recommend 'Seal All' for the rubber o-rings. I've never used a sealant like that on o-rings...only motor oil or vasoline. Anyone use the stuff?
MKIV Roadster - #9380 - Complete Kit - Delivered 7/17/18 - SOLD 5/2023
Build Thread #1: https://thefactoryfiveforum.com/show...V-Build-Thread
MKIV Roadster - #TBD - Complete Kit - Delivered 11/6/23 - In Progress
Build Thread #2: https://thefactoryfiveforum.com/show...Build-Thread-2
I use Molykote 111 on rubber gaskets and o-rings. Commonly used in the Porsche world
https://www.amazon.com/dp/B00CTUJNU2...537429950&sr=1
If you are talking about the o-ring around the fuel pump and fuel gauge, motor oil as per Ford, same for the fill tube.
Are they suggesting using seal all instead of an o-ring?
FFR MkII, 408W, Tremec TKO 500, 2015 IRS, DA QA1s, Forte front bar, APE hardtop.
They are suggesting to use the Seal All on the o-rings of the fuel tank sender and pickup. Here's the video. They apply the Seal All at 1:43 and 2:38
https://www.youtube.com/watch?v=ybGdqmVyDV4&t=200s
MKIV Roadster - #9380 - Complete Kit - Delivered 7/17/18 - SOLD 5/2023
Build Thread #1: https://thefactoryfiveforum.com/show...V-Build-Thread
MKIV Roadster - #TBD - Complete Kit - Delivered 11/6/23 - In Progress
Build Thread #2: https://thefactoryfiveforum.com/show...Build-Thread-2
FFR supplies a Dorman aftermarket Mustang tank....close, but not exactly like a ginnie Ford tank. When I build I use a sealant. On a Ford tank with Ford O-Ring I use a lightweight oil..Da Bat
MKIV Roadster - #9380 - Complete Kit - Delivered 7/17/18 - SOLD 5/2023
Build Thread #1: https://thefactoryfiveforum.com/show...V-Build-Thread
MKIV Roadster - #TBD - Complete Kit - Delivered 11/6/23 - In Progress
Build Thread #2: https://thefactoryfiveforum.com/show...Build-Thread-2