I cancelled the steering wheel that came with my kit. I am looking to buy one I prefer more, what is the bolt pattern here called? What should I be looking for?
http://www.factoryfiveparts.com/1252...ng-wheel-boss/
Visit our community sponsor
I cancelled the steering wheel that came with my kit. I am looking to buy one I prefer more, what is the bolt pattern here called? What should I be looking for?
http://www.factoryfiveparts.com/1252...ng-wheel-boss/
P100DHG’s Gen 3 65 Coupe #138 Build Thread - Order Date: Aug 2018 - Delivered: Feb 2019 -
First Start: May 2020 - First Drive: January 2021 - Instagram @SixtyFive_Daytona
Pretty sure its FFR specific. It is not a consistent bolt circle either.You may be able to drill the hub to match whatever you buy though.
Mike
You might send a note to Russ Thompson, as he does custom machining on the steering wheel boss for his turn signal setup. He may be able to provide the specs and offer recommendations on what would fit.
My Build Thread: http://thefactoryfiveforum.com/showt...ter-Build-9754
(Most viewed Roadster build thread on this forum!)
Delivered: 6/17/2017
First Start: 12/30/2017
Completed: 12/7/2019
Legal: 1/30/2020
Member of the Mile-Hi Cobra Club
Dave's Cobra YouTube Channel: https://www.youtube.com/channel/UCbk...npK1UZHj4R-bYQ
Agora 1:8 Scale Cobra Build: https://thefactoryfiveforum.com/show...l-Build-Thread
Is the steering rack universal that I can just use a boss that comes with steering wheel like this
https://www.ebay.com/itm/65-1969-For...08b6%7Ciid%3A1
Another example
https://www.ebay.com/itm/1978-to-199...08b6%7Ciid%3A1
Last edited by P100DHG; 11-24-2018 at 01:34 PM.
P100DHG’s Gen 3 65 Coupe #138 Build Thread - Order Date: Aug 2018 - Delivered: Feb 2019 -
First Start: May 2020 - First Drive: January 2021 - Instagram @SixtyFive_Daytona
If you want a different wheel then you may want to install a Quick Disconnect like one of the types shown below since they have multiple patterns:
https://www.jegs.com/p/JEGS/JEGS-Qui...58026/10002/-1
Also, check out this earlier forum thread if you want to see other solutions:
https://thefactoryfiveforum.com/show...+quick+release
You just need to have the wheel spline Tig Welded to the 3/4" shaft.
Last edited by GoDadGo; 11-24-2018 at 06:14 PM.
Just to give resolution to this thread, I’m sending out my boss to Russ Thompson he has the Momo bolt pattern.
P100DHG’s Gen 3 65 Coupe #138 Build Thread - Order Date: Aug 2018 - Delivered: Feb 2019 -
First Start: May 2020 - First Drive: January 2021 - Instagram @SixtyFive_Daytona