Tony Talked me into a Mark IV

[Goldeneaglerv]

Well guys it was a quick decision after spending some time on the phone with Tony, A Mark IV is in my future... So the only problem I have is he stated that FF no longer makes headers for a 427… Not a stroker but a true FE block... Any thoughts where I can locate a set?

[BadAsp427]

Start with Georgie at GAS-N

[Goldeneaglerv]

Start with Georgie at GAS-N

Thnaks… Great Build Thread

[Jeff Kleiner]

.. So the only problem I have is he stated that FF no longer makes headers for a 427…

FFR didn't make them anyway, Hooker did. You could check with them and see if they can dig out their jigs and make a set.

Jeff

[frankb]

Goleneaglerev: Congrats on your decision! Have you pulled the trigger yet? Stainless Headers www.stainlessheaders.com manufactures custom headers if all else fails. If you are a handy guy with a welder, you can build your own. Not easy, but if I can do it, so can you!
IMG_20160118_125545102_HDRr.jpg IMG_20160125_150415674r.jpg

Frank B

[John4337]

Congratulations and enjoy the build, but if you think Tony talked you into something, wait until you see what the guys on this forum talk you into ;-)

John

[Avalanche325]

Congrats!

Yeah, John is good at spending my money. Soft top, head rests........

[Goldeneaglerv]

Thanks Guys getting excited looking at lots of great ideas from everyone's builds