Visit our community sponsor
Thanks:
0
Likes:
1
-
Senior Member
SBC/Tremec Transmission Mount Spacer
Trying to determine the Transmission Mount Spacer dimension to get correct Alignment/Clearance for the Drive Shaft. I temporarily just set the Yoke on a 1/4" piece of plywood to get an approximate height. How critical is this dimension. I did modify the SBC Engine Mount to clear the Front Pulley by machining Bushing to move the Engine back about 1/2">>
trans.jpgengmt.jpj.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor