I've had my kit for 8 month and have finally started doing something with it. I purchased ahead of my schedule to take advantage of the Black Friday sale in 2017. I picked it up in late April, 2018. Fast Forward 8 months and I was ready to get started. Last night, I marked, removed, and drilled the aluminum. I also re-assembled the UCAs. This morning, I assembled the coil-overs and clamped the F-panels to the chassis and drilled through the panel holes. I removed the panels and panted the engine side with silver hammer tone.
20190105_151226.jpg
I then mocked up the pax front suspension. I did not tighten anything down. I was hoping you all could take a look and let me know if I missed something. If all is good, I'll disassemble, clean everything up good, and assemble, torque down. I did have a question, if the LCA bracket is a bit wide, should I fill in the gap with one of he large fender washers? If I can, I'll hold off on permanently attaching the F-Panels.
20190105_150339.jpg20190105_150349.jpg20190105_150800.jpg
Not sure why the pictures are sideways.
Thanks, Rob