Anyone used 2” FF roll bars on an MKIV? I recently saw a post on one of the Facebook sites stating such. Curious what modifications are necessary.
Visit our community sponsor
Anyone used 2” FF roll bars on an MKIV? I recently saw a post on one of the Facebook sites stating such. Curious what modifications are necessary.
MKIV #9542 Complete Kit, Coyote, IRS - Delivered - 2/19/19, First start - 9/8/19, Go Cart - 9/14/19
1965 Mustang Convertible 4v 289
Build Thread HERE
You just need to make some intermediate sleeves to go in-between the roll bar stubs and the roll bar. One of our customers likes the look of the 2" bar and is putting one on his MK4.
I did it on a MK 4, opened up body holes and massaged the frame tubes so the 2" roll bar tubes went over instead of inside the tubes like the 1.5"
I make the stumps for the 2 inch roll bar. I could be persuaded to run a batch if enough people were interested.
Mike
How much will a set cost. 2 roll bars. Thanks
Mike - I’m very interested in two sets of stubs! I have a kit in order (completion next week) and am torn on rollbars. If I knew I could get the stubs I would probably have the 1.5” traded for the 2” rollbars. I also sent you a PM.
MKIV #9542 Complete Kit, Coyote, IRS - Delivered - 2/19/19, First start - 9/8/19, Go Cart - 9/14/19
1965 Mustang Convertible 4v 289
Build Thread HERE