Visit our community sponsor
Thanks:
2
Likes:
10
-
Did I break it? I think I did. (Gauges, EEPROM swap)
I attempted to reset my mileage to zero. I bought a chip, and desoldered the old one. At least I tried to. 6 of the 8 pins worked, but 2 were resistant to melting. I cut the 2 pins off and tried some more. I still couldn't desolder them.
So I just soldered the new chip in, and soldered the affected area to the old solder.
Hooking it up, I was optimistic. Evidence shows, I shouldn't have been.
20190125_094038.jpg
Would you try to redo it, or do you all believe I've ruined the chip and/or board?
I should probably try again, but you guys/gals are much smarter than me.
Thank you.
Last edited by Ipassgas; 02-01-2019 at 11:23 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor