ReinCarNation

Visit our community sponsor

Thanks Thanks:  1
Likes Likes:  1
Results 1 to 6 of 6

Thread: replicaparts GEN 2 build thread

  1. #1

    Join Date
    Feb 2011
    Location
    Norton, MA USA earth
    Posts
    2,209
    Post Thanks / Like

    replicaparts GEN 2 build thread

    I am going to start a build thread chronicling the build of my first GEN 2 HotRod. I will do my best to keep up with it.

    I picked up the kit for a customer on Feb 2 2019 The car will feature just ab out every option that FFR has including the following
    IRS
    Early chevy install kit
    Chrome tilt clumn
    Wilwood brakes
    hard top
    soft top
    full fenders
    A/C and heat
    Leather seats
    Coupe gauges

    I am sure there are a few I'm missing.

    Here are a few pics of the pickup








    I managed to fit all these boxes in my SUV and a few tucked in the kit and on the trailer.
    Will need to go back for the full fender kit.








    Here are a few pics of it at my shop and being off loaded.

  2. Thanks Mrallsport32 thanked for this post
    Likes FF33rod liked this post
  3. #2

    Join Date
    Feb 2011
    Location
    Norton, MA USA earth
    Posts
    2,209
    Post Thanks / Like
    I started going through the back order list and doing inventory. The back order list is very short and didn't contain anything that will slow me down right now.
    I started this afternoon by assembling the shocks. I did both front and rear. Nothing unusual or different here.



    After they were packed away I replaced the wheel studs in the rear IRS hubs. I knocked out the old ones with a large hammer. Used a hydraulic press to install the new ones. Pretty straight forward.





    Hope to really get going on it Monday morning.

  4. #3
    Member
    Join Date
    Jun 2015
    Location
    Arlington, VA
    Posts
    39
    Post Thanks / Like
    Mike,

    That roadster behind it is really dusty. Could you run a rag over it for me?


  5. #4

    Join Date
    Mar 2018
    Location
    Yucaipa, CA
    Posts
    89
    Post Thanks / Like
    Blog Entries
    1
    In those pics you can really see the added Radius they put into the doors. Then I see some small changes to the frame. Should be a very nice build. Good luck.

  6. #5
    Senior Member John Dol's Avatar
    Join Date
    Feb 2011
    Location
    Gorham, ME
    Posts
    952
    Post Thanks / Like
    Nice Mike, and sweet shop too!

    John
    Making progress on the "My Coupe, my way" project.

    http://s956.photobucket.com/albums/ae46/jdcoupe1969/
    Coupe #386,17" Team III 245 FR 315 RR, 3-link, T5, 4 wheel disk, power brakes/steering. Fast EZ EFI
    First start Sept. 18 2013 First go kart Sept 19 2013

  7. #6
    Junior Member
    Join Date
    Aug 2017
    Location
    Cotati California
    Posts
    4
    Post Thanks / Like
    Nice. I will be following your build. My gen 2 33 is scheduled to delivered this week to nor cal. I’m also using a sbc.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Flat Irons Tuning

Visit our community sponsor