I've FINALLY finished tweaking and cleaning up the frame, and test-fitting control arms etc. and I'm ready to send it off for powder coat. In addition, I've rounded up a bunch of parts that I'll be powder coating in this first batch along with the chassis. I want to make sure I'm not missing anything obvious that I could/should PC now. It's not the end of the world if I miss something, as I can send it out with the sheet metal batch, but it would be nice to get a good chunk of the stuff done now. Here's what I've rounded up so far:

- Metco driveshaft safety loop
- transmission brace (it's already PC'ed black, but I'm going to have it recoated to match the rest of the frame)
- sway bar mounts
- door hinges
- pedal box brackets
- trunk hinges
- front body/light brackets
- Breeze battery box
- Breeze lower radiator mount rod
- hood hinge parts
- Door latch doodads (I think that's the technical term)

I still need to go through and ease all the edges and deburr them. Is there anything else obvious that I should throw into this first batch of parts?

Thanks,
John