Does anyone have one that I can borrow? Will pay shipping both ways.
Visit our community sponsor
Does anyone have one that I can borrow? Will pay shipping both ways.
What are you looking for?
2020 Mark 4, Coyote 5.0, gen 3, complete kit, solid rear. Started 3/22/20
I bought one of those 10. I used it on my Exocet, and then lent it out. Haven't seen it since.
.boB "Iron Man"
NASA Rocky Mountain, TTU #42, HPDE Instructor
BDR 1642: Coyote, 6 Speed Auto, Edelbrock Supercharger
Member: www.MileHiCobraClub.com
www.RacingTheExocet.com
I saw posts with pictures - cant find them now! Here is two reference links
https://thefactoryfiveforum.com/show...S-Pedal-Bender
https://www.ffcars.com/threads/pedal...anyone.515009/
Any pictures of the bender would be appreciated!
Mk3.1 347 AFR 205cc Heads A9L EFI siemens deca 60lb injectors MSD 6AL ignition Vortech V-3 3 Link PS/PB
-- If you can’t fix it with a hammer, you have an electrical problem ! —
I don't know if this helps anyone, but I found this thread with a CAD drawing of the pedal bender on the other forum. I think anyone with a mill could make one pretty easily. I've been toying with the idea of buying a bench top mill for a while. If I had one, I'd make a few of these just for practice and fun.
https://www.ffcars.com/threads/pedal-bender.266971/
MkIV Roadster build: Gen 2 Coyote, IRS, TKO600. Ordered 10/24/18. Delivered 1/29/19. Engine installed 8/8/21. First start 9/12/21. First go-kart 9/17/21. Off to paint 4/11/22. Back from paint 12/30/22. Build thread here.
It would seem from reading over the posts on the links, Just Puttering posted, that MrMustang would be the fellow to contact, re the bender.
I don't think they are in circulation quite as much as they were at one time, since the Wilwood pedal system has come into play, but they are great for anyone still using the donor pedal set up.