Visit our community sponsor
Thanks:
29
Likes:
194
-
Well, I started knocking the seams on the body on the Mark III Body. Not too bad. I also reworked the trunk to make it fit.
I ground a little off the long bolt sleeve of the both pairs of rear body bolts. I spent a few hours grounding till I got the trunk to fit just right.
I also cut the hood scoop out of the hood. It was 1" off and tilted back towards the passanger side. Laid some resin and matt to build up one side and cut the other. Now working on the stepped reveal on the inside. I am tired, but making good progress.
Last edited by donpny; 02-26-2011 at 06:19 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Visit our community sponsor
Reply With Quote